Airtec Plastic One-piece Ceiling Diffuser

Burt Robertson, HVAC Marketing Manager

The quickest, smartest way to get the job done is with Airtec. The MV ceiling diffuser is a boot and damper all in one, it installs in seconds with just a few easy steps. Cut a simple round hole in the ceiling, attach the Model MV to your flex duct with the tie straps which are included. Push the MV into place in the hole and tighten the four screws which rotate the mounting clips into position as you tighten. That's it. The stepped collar design accommodates 6”,7” and 8” on the MV and 4”5” and 6” on the mini MV. The unneeded collar sections are removed using tear away bands, no cutting or assembly is required.

Time tested. For over 12 years Airtec has manufactured the MV series diffuser here in the U.S.A. using the highest grade plastic, proven not to yellow. This damper has a rubber gasket for a virtually air tight shut-off making it far superior to any others on the market. The mounting clips are sized to fit under joists with screws long enough to reach over furring or other obstructions. All model MV's include an attractive handle for damper control which can be snapped in or left out.

Yaun Company also stocks the Airtec grille which can be used on the ceiling or the sidewall, look great and have many uses and are great to use in bathrooms where a steel grille would rust. The MV ceiling registers come in 2-way, 3-way and 4-way diffuser pattern. Rough in mounting plates and tee bar mounting plates are also stocked to make using this product easy.

Airtec, think fast, work smart.